电动扳手与套筒连接的方式有三种，每种方式在使用中都有各自的注意事项，下面电动扳手厂家来详细介绍下。
There are three ways to connect electric wrench with sleeve. Each way has its own precautions in use. The following electric wrench manufacturer will introduce in detail.
扳手与套筒连接种方式是卡环方式，注意事项:
The first way to connect the wrench with the sleeve is the clasp way.
a.本方法仅适用于M16以下螺丝。
A. This method is only applicable to the screw below M16.
b.保持弹簧外的余度在0.8mm以上。
B. Keep the surplus outside the spring above 0.8 mm.
电动扳手弹簧球方式注意两点：
Two points should be paid attention to in the spring ball mode of electric wrench:
a.本方法仅适用于M16以下螺丝。
A. This method is only applicable to the screw below M16.
b.在连接前确认上图中弹簧球的动作。
B. Verify the action of the spring ball in the picture above before connecting.
扭剪扳手:电动扳手与套筒连接的三种方式
Torsion wrench: three ways of connecting electric wrench with sleeve
扳手与套筒连接第三种方式就是橡皮销固定方式，注意三点：
The third way to connect the wrench to the sleeve is to fix the rubber pin. Pay attention to three points:
a.使用前应当确认橡皮套没有开裂、弹性减少等老化。
A. Before use, it should be confirmed that the rubber sleeve does not crack, and the elasticity decreases.
b.销子的外径尺寸是孔径-0.5mm。
B. The outer diameter of the pin is - 0.5mm.
c.销子、橡皮压紧件应当使用正规的产品，不得使用自己制作的或者现有的。
C. Pins and rubber pressing parts shall be made of regular products and shall not be made by themselves or existing ones.
以上
扭剪扳手厂家给大家详细介绍了扳手与套筒的三种连接方式，希望可以帮大家加深了解。
The above wrench manufacturer has introduced three connection ways between wrench and sleeve in detail, hoping to help you understand more about .
